Steve Lovelock
|
| posted on 16/4/07 at 10:32 PM |
|
|
Has anybody used the Luego dash layout?
I have been looking at the Luego build manual regarding the dash board and noticed that the panel sits behind the return of the scuttle as shown
below. However, the return on my scuttle is not flat and as I am using a reasonably flexible material for the dash I am a little worried that it will
be bent out of shape. Has anybody made their dashboards as suggested because all the dashboards I have seen pictures of are fixed from the front. I
am planning on using 4mm carbon effect plastic for my dash.
 
Rescued attachment image062.jpg
|
|
|
|
|
piddy
|
| posted on 16/4/07 at 11:03 PM |
|
|
Yes I have.
I used one of those contoured carbon affect jobbies. I put a rubber U channel around the scuttle and then bolt the two
together..jpg)
|
|
|
Danozeman
|
| posted on 17/4/07 at 05:44 AM |
|
|
Mine isnt completely flat either. When i trial fited my dash i screwed up flat. Iv got apadded panel on there now so everything is all nice.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
jollygreengiant
|
| posted on 17/4/07 at 10:56 AM |
|
|
Yep same as Luego suggest & looks very similar to yours. Managed to get a slight curve on lower edge of dash into cockpit area by use of rear prop
on lower edge whilst drilling mounting holes through wood.
 
First attempt at dash
Beware of the Goldfish in the tulip mines. The ONLY defence against them is smoking peanut butter sandwiches.
|
|
|
