Bumble
|
| posted on 27/5/10 at 05:25 PM |
|
|
M16 Calipers.......Help please..........
Hi all,
How do the little springs attach to the M16 calipers? Anyone got a pic/diagram that shows how they attach.
Thanks,
Matt
 
Rescued attachment M16 Caliper & Spring.JPG
|
|
|
|
|
philw
|
| posted on 27/5/10 at 05:39 PM |
|
|
IIRC the looped bits go around the pin, there should be a tiny hole drilled in the caliper casing behind the pads and the pointy ends of the spring
fit into the hole, HTH, crap explanation i'm sure someone will do better
Must try harder
|
|
|
MkII
|
| posted on 27/5/10 at 05:48 PM |
|
|
the looped bits go round the pin, the "lugs" on the outside of the spring fit against the edge of the metal pad back (the edge the camera
is looking directly at) and the ends of the spring fit into holes in the pad back the holes inbetween the pin holes . I could fit them for you in
about ten seconds but its taken about ten minutes to describe how to do it(and Im still not sure it makes sense) .m.
[Edited on 27/5/10 by MkII]
|
|
|
Bumble
|
| posted on 27/5/10 at 06:02 PM |
|
|
A bit like this then......
Thanks to all.
Matt
 
Rescued attachment IMG_5915.JPG
|
|
|
MkII
|
| posted on 27/5/10 at 06:21 PM |
|
|
that looks how I think it should go .m.
|
|
|
paulf
|
| posted on 27/5/10 at 08:49 PM |
|
|
What are they for? .Ive never had any on my car, the calipers were reconditioned and there were none with the pads either so I assume you can safely
through them away.
Paul
|
|
|
MikeR
|
| posted on 3/8/20 at 12:04 PM |
|
|
10 years after the original post, I'm trying to figure out how to fit these and after random web searches this site comes up trumps (referenced
from wscc)
Thank you.
And just in case anyone knows, the metal shims that goes between the piston and pad, does the arrow point to the sky (direction of brake disc travel)
or floor?
|
|
|
rusty nuts
|
| posted on 3/8/20 at 01:36 PM |
|
|
The arrow points in the direction of rotation. Bit late for Paul but the springs are for anti rattle
|
|
|
.jpg)
.jpg)
