Board logo

New Driveshafts
NS Dev - 29/3/06 at 09:34 AM

My new driveshafts from GB Engineering turned up at work this morning, will post a pic tonight before I fit em, very nicely made as usual.

ned - 29/3/06 at 09:58 AM

wow, where'd you get them from, would you recommend this supplier?

James - 29/3/06 at 10:11 AM



NS,
Any chance of you weighing them before you stick them in. Just interested!

Cheers,
James

Wadders - 29/3/06 at 11:01 AM

Nat forgot to thank you for the contact, mine arrived last week, and yes they are a fine piece of engineering, about 2/3 the weight of my old ones. Thumbs up for GB eng.



Originally posted by NS Dev
My new driveshafts from GB Engineering turned up at work this morning, will post a pic tonight before I fit em, very nicely made as usual.

NS Dev - 29/3/06 at 12:18 PM

quote:
Originally posted by James


NS,
Any chance of you weighing them before you stick them in. Just interested!

Cheers,
James


just stuck one on the post scales, 1550 grammes (and they are 435mm long)

Flat Pack - 29/3/06 at 12:42 PM

quote:
Originally posted by Wadders
Nat forgot to thank you for the contact, mine arrived last week, and yes they are a fine piece of engineering, about 2/3 the weight of my old ones. Thumbs up for GB eng.


And from me, had mine a week or so too now. Am I the only one that manages to make a right mess cleaning up and fitting CV joints? Grease everywhere...

NS Dev - 29/3/06 at 12:43 PM

nah, moly grease every flipping where!

NS Dev - 29/3/06 at 07:42 PM

Here ya goes:
(the black lines near the splined ends are stains)

shafts 1
shafts 1

[Edited on 29/3/06 by NS Dev]