Have bought the connector below to build a loom for the ECU. I was wondering whether anyone else went this DIY route and if they could go over how the connector is assembled.

http://www.polevolt.co.uk/acatalog/info_ECU36.html

Which side are the pins inserted from? How easily are they extracted once in? Do you need a special tool to do so?

Thanks

Andy

Connector pins are inserted into the housing from the back. You have to release the latch from the front if you want to remove a pin, and you can do it with a small jewellers screwdriver. They are quite easy to assemble, just make sure you put the seal onto the wire before you crimp the receptacle on (the end with the "nipple" points towards the crimp).

hi will this fit the omex 600.thanks

anyone !!!

Hi yes this is the correct connector for the Omex 600 ecu ,we use them all the time speak to Neil at Polevolt