I have just received the throttle linkage to go with the raceline jenvey throttle bodies.

Has any one fitted these and had a problem with the clearance between the linkage and the body of the throttle body??

I'm not going to get a file on it as these were too expensive to bodge up.

Any ideas??

Cheers Mark
Rescued attachment jenvey.jpg

Just guessing - not tried them myself, but perhaps the arm will go on in a different position say 90 Deg from where you have it?

HTH

Mark

Mine is exactly the same. I plan to shorten the thread and use a half nut secured with thread lock.

Mick

Will the linkage attach to the arm on the other end.

In other words, can you make it a pull arrangement rather than a push (or vice versa) ??

Tigger

some good suggestions I'll try thank.

Cal vinx - hinesight (spelling) is a wounderful thing, thanks for making me feel better

Mark