Board logo

Mondeo/Focus downpipe wanted.
r1_pete - 27/2/08 at 12:31 PM

Downpipe to suite the cast manifold as below wanted, anyone got one left over from their donor? only need the flange and a few inches of pipe.
Cheers.
Pete. Rescued attachment exhaust.jpg
Rescued attachment exhaust.jpg


adithorp - 27/2/08 at 01:11 PM

I've got the cast flange bit that then becomes a taper cup type connection about 3" down. Your's if you want it.

adrian


r1_pete - 27/2/08 at 01:21 PM

Sounds like it will do the job, going in the MGB, so as long as I can weld a couple of bends on it'll be fine.

You ok Posting it? how much do you need?

Cheers.
Pete.


adithorp - 27/2/08 at 01:32 PM

Its a cast oval flange with 4 bolt holes slightly ofset from the ends/corners on the manifild end. 3" casting then got a 2 bolt flange with 2" pipe through it. Total length 5". Came of an early Mondeo and has been sat on a shelf for years gathering dust.

I'll send it today if you want via the firm next doors courier contract. I won't know how much till later (if he ever gets around to letting me know!) but probably not more than a fiver.

u2u me your address.