dyntan
|
| posted on 20/1/07 at 10:40 PM |
|
|
ENGINE MOUNTING
HI ALL
CAN ANYONE ADVISE ME HOW BEST TO MOUNT AND POSITION MY 16 CROSSFLOW AND TYPE 9 GBOX.
DO YOU ADVISE BUYING MOUNTING BRACKETS OR GO TO THE TROUBLE OF FABRICATION
MANY THANKS PAUL
|
|
|
|
|
caber
|
| posted on 20/1/07 at 10:50 PM |
|
|
DON'T SHOUT!
probably easiest to fabricate something that will work using a standard mount rubber.
Caber
|
|
|
wilkingj
|
| posted on 20/1/07 at 10:53 PM |
|
|
1st .. as Noobie.. Welcome.
2nd... Please dont SHOUT... Capitals are considered as SHOUTING
I would do the longitudinal axis, as the best place for the gearlever for driving.
Also to get the whole lot as far back as is possible without making it too tight. This will bring the weight to the centre of the car helping the
balance.
side to side... well in the centre!!
Then make the propshaft to suit, unless you already have a good propshaft.
Edit:
Also consider the exhaust position, and perhaps the alternator. ie trial fit the engine with the ancillaries fitted, so you have room to refit them
after you have mounted the engine and box.
Use blocks of wood to position the engine and box, then measure up and make the mounts. (or buy)
Height wise, well you want some ground clearance! But will depend on what engine. Some will need the sump cutting down. Also consider the bonnet line
so th bonnet closes!
Engine mounts, well buy them if you cant weld
[Edited on 20/1/2007 by wilkingj]
1. The point of a journey is not to arrive.
2. Never take life seriously. Nobody gets out alive anyway.
Best Regards
Geoff
http://www.v8viento.co.uk
|
|
|
ayoungman
|
| posted on 20/1/07 at 11:02 PM |
|
|
Get the engine sat in the centre of the chassis. sit it on wooden blocks, milk crates or whatever, then adjust the height with spacer pieces of wood.
ensure the engine is on the centre line of the chassis.
You can then work out what brackets are needed to support the engine. I made mine, it wasn't that difficult.
 
Rescued attachment engine mounts painted.JPG
"just like that !"
|
|
|
scutter
|
| posted on 20/1/07 at 11:24 PM |
|
|
Home made here as well, the rubber gearbox mount can be mounted on two pieces of flat plate welded to the underside or the tunnel.
 
basics
ATB Dan.
The less I worked, the more i liked it.
|
|
|
andrew-theasby
|
| posted on 21/1/07 at 12:42 AM |
|
|
mine were slightly different but still home made. dont forget to allow for your engine dropping a little when you put the engines weight on the
rubbers
 
Rescued attachment mount1.JPG
|
|
|
gazza285
|
| posted on 21/1/07 at 02:12 AM |
|
|
ayoungman and andrew-theasby, not wishing to upset you or denigrate your work but from the pictures you have posted I would recommend a little more
welding practice.
DO NOT PUT ON KNOB OR BOLLOCKS!
|
|
|
dyntan
|
| posted on 21/1/07 at 07:43 PM |
|
|
Many thanks for all the advice and sorry for SHOUTING wasnt aware
|
|
|
