macspeedy
|
 posted on 11/1/07 at 02:35 PM |
|
|
Pinto plumbing
Have seen lots of people asking how to plumb in the rad etc on pintos heres a photo to help explain
 
Rescued attachment Pinto plumbing diagram.JPG
|
|
|
|
|
macnab
|
| posted on 11/1/07 at 02:59 PM |
|
|
Admit it your just showing off all your shiny fancy bits.
Looks like you have spent a fortune on that engine.
Wish my pinto looked that good
[Edited on 11/1/07 by macnab]
|
|
|
James
|
| posted on 11/1/07 at 05:06 PM |
|
|
Macspeedy,
Engine looks lovely! 
In that setup, what do you do for the return from the heater matrix?
Or if you don't have a matrix?
Cheers,
James
[Edited on 11/1/07 by James]
------------------------------------------------------------------------------------------------------------
"The fight is won or lost far away from witnesses, behind the lines, in the gym and out there on the road, long before I dance under those lights."
- Muhammad Ali
|
|
|
macspeedy
|
| posted on 11/1/07 at 08:25 PM |
|
|
James
The return from the matrix goes to the block as shown, if you don't have a matrix then join it to the return pipe or expansion bottle.
Thanks for the kind words guys
|
|
|
roadrunner
|
| posted on 11/1/07 at 09:31 PM |
|
|
Heater matrix! whats that?
[Edited on 11/1/07 by roadrunner]
|
|
|
ayoungman
|
| posted on 11/1/07 at 10:06 PM |
|
|
Its the thing just below the Flux Capacitor
"just like that !"
|
|
|
