donut
|
posted on 4/7/05 at 02:47 PM |
|
|
LT77 gearbox ?
Anyone know what an LT77 gearbox is? Who makes it and could it be mated to a chevy 350 engine?
Ta
Andy
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.
http://www.flickr.com/photos/andywest1/
|
|
|
Snuggs
|
posted on 4/7/05 at 02:55 PM |
|
|
Andy Check here.
http://www.rpiv8.com/transmission-3.htm
Clive
----------------------------------------------------------------------------------------------------
http://www.topcashback.co.uk/ref/snuggstcb
Spider pig, spider pig, does whatever a spider pig does.
I doubt therefore I may be.
Luposlipophobia : Fear of being chased by wolves around a freshly waxed kitchen floor, while wearing only socks on your feet.
My mind not only wanders, sometimes it leaves completely!
http://www.venganza.org
http://www.jesusandmo.net/
http://www.snuggs.co.uk
|
|
gazza285
|
posted on 4/7/05 at 02:57 PM |
|
|
Have a look here
http://www.rpiv8.com/transmission-3.htm
Should be enough to get you to look for a proper gearbox.
|
|
gazza285
|
posted on 4/7/05 at 02:57 PM |
|
|
Too quick for me
|
|
clbarclay
|
posted on 4/7/05 at 03:02 PM |
|
|
Broadly speeking the LT77 was the standard gearbox found mated to the 3.5 and 3.9 rover V8 in just about and car/vehicle.
Bolt a transfer box on the back and its virtually the same as ones used in landrovers. The same goes for the R380.
LT77 can also be found rover P6
[Edited on 4/7/05 by clbarclay]
|
|
donut
|
posted on 4/7/05 at 04:09 PM |
|
|
Sweet
Cheers chaps, that answers my question...
Andy
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.
http://www.flickr.com/photos/andywest1/
|
|
Donners90
|
posted on 4/7/05 at 07:10 PM |
|
|
Sign up here...
http://www.v-8.org.uk/forum/default.asp
A forum specialising in V8 powered vehicles. As the RV8 is a popular unit there is a fair bit of info on there regarding the LT77.
I'm sure they can advise on the best route to go with the Chevvy/LT77 combination.
Assuming you use the LT77 in your Cobra then you'll probably need the remote gearchange from the Sherpa van or TVR. Something like the pic
below!
HTH
James
Rescued attachment sherpa remote.JPG
|
|
rusty nuts
|
posted on 4/7/05 at 07:24 PM |
|
|
The gearbox used in the Rover P6 was a 4 speed unit , isn't the LT77 a 5 speed ? Also the 4 speed box wasn't too clever even with about
170BHP . Suspect it wouldn't last long with a Chevy lump
|
|
wilkingj
|
posted on 4/7/05 at 08:24 PM |
|
|
FORGET putting a LT77 (light transmission with 77mm between the shafts) in with a Chevy... It will rip its poor little heart out. Wayyyyyyy too much
power and torque.
A 3.9 rover and 200bhp is pushing its limits or thereabouts.
R380 is a much modified LT77 and somewhat better. However, I would think twice about even using that as well.
LT77 / R380 are Rover Boxes fitted to Land Rovers, Some range Rovers, SD1's, triumph TR7's and 8's (I think) and some MGB
RV8's.
You will need something much better like Tremec or simmilar.
1. The point of a journey is not to arrive.
2. Never take life seriously. Nobody gets out alive anyway.
Best Regards
Geoff
http://www.v8viento.co.uk
|
|
Simon
|
posted on 4/7/05 at 10:28 PM |
|
|
Agree with Geoff
Have a look at http://www.tremec.com/English under "light" applications - these are upto approx 600lb ft torque
ATB
Simon
|
|
donut
|
posted on 5/7/05 at 06:20 AM |
|
|
Cheers Simon that link is actually very helpful.
Ta
Andy
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.
http://www.flickr.com/photos/andywest1/
|
|
clbarclay
|
posted on 5/7/05 at 11:37 AM |
|
|
quote: Originally posted by rusty nuts
The gearbox used in the Rover P6 was a 4 speed unit , isn't the LT77 a 5 speed ? Also the 4 speed box wasn't too clever even with about
170BHP . Suspect it wouldn't last long with a Chevy lump
I thought that was just the P5, serves me right for listening to my farther.
|
|
rusty nuts
|
posted on 5/7/05 at 06:54 PM |
|
|
All of the P5 V8s (P5B) had the Borg Warner slushbox
|
|
Simon
|
posted on 5/7/05 at 09:45 PM |
|
|
quote: Originally posted by donut
Cheers Simon that link is actually very helpful.
Ta
Donut,
You sound surprised (that I'd come up with something useful)
ATB
Simon
|
|
donut
|
posted on 5/7/05 at 10:11 PM |
|
|
Andy
When I die, I want to go peacefully like my Grandfather did, in his sleep -- not screaming, like the passengers in his car.
http://www.flickr.com/photos/andywest1/
|
|