ayoungman
|
| posted on 2/2/05 at 09:05 AM |
|
|
plumbing in pinto
Question, can someone give me a simple+correct ! method of plumbing this lot together ?
polo rad+ pinto+heater+expansion tank+weber downdraft with coolant connection.
answers on a postcard+small prize to the winner !
"just like that !"
|
|
|
|
|
Avoneer
|
| posted on 2/2/05 at 09:07 AM |
|
|
I posted a pic a while back.
Will try and find it later.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
James
|
| posted on 2/2/05 at 09:37 AM |
|
|
There's loads of posts on this. Have a look through the archives.
HTH,
James
|
|
|
Mark Allanson
|
| posted on 2/2/05 at 07:15 PM |
|
|
I don't have a heater or the webers (injection instead). I do have an additional expansion bottle with the micra rad
 
Rescued attachment Plumbing3.jpg
If you can keep you head, whilst all others around you are losing theirs, you are not fully aware of the situation
|
|
|
Jon Ison
|
| posted on 2/2/05 at 08:08 PM |
|
|
id'e miss out the inlet manifold connection, cooler the charge the better.
|
|
|
JoelP
|
| posted on 2/2/05 at 09:11 PM |
|
|
a short summary (agrees with all the above too, BTW) is:
bottom of rad to bottom of engine
top to top.
expansion bottom into bottom hose via tee
expansion top from top hose.
heater matrix just looped back on itself.
There are several variations in donor sierras on how the same setup was actually connected - mine had a few bits plugged when i dismantled it. So i
left it all as it came
|
|
|
%20(WinCE).JPG)
