TurboWood
|
| posted on 15/7/15 at 05:26 AM |
|
|
Ford Type9 spacer drawing
Hi Gents,
I'm working on a 7 and need a spacer for my transmission. I've searched and know there are a few options out there, but the easiest part
(requires less custom work) is the 30mm spacer from caterham. Unfortunately I cannot find any anywhere.
Does anyone have a drawing or the critical dimensions that I could make drawing from? This is for the Ford type 9 transmission. I would happily buy a
used one if anyone has one sitting around.
Thanks,
Daniel
|
|
|
|
|
rusty nuts
|
| posted on 15/7/15 at 07:00 AM |
|
|
Retro ford RWDmotorsport or use the search facility on here
|
|
|
Paul Turner
|
| posted on 15/7/15 at 07:56 AM |
|
|
From memory off the shelf the RWD one is thinner but they will make one to the full 30mm if you ask.
Have you tried a wanted in the Caterham forum?
|
|
|
TurboWood
|
| posted on 15/7/15 at 01:50 PM |
|
|
Thanks for the help guys. I've sent some notes based on your suggestion.
Daniel
|
|
|
owelly
|
| posted on 16/7/15 at 01:31 PM |
|
|
I took these measurements when I made my spacer. I accept no responsibility if they are all wrong but it seemed to work for my purpose!!
 
Type9 flange dims
http://www.ppcmag.co.uk
|
|
|
Benzo
|
| posted on 2/12/19 at 11:27 AM |
|
|
quote:
Originally posted by owelly
I took these measurements when I made my spacer. I accept no responsibility if they are all wrong but it seemed to work for my purpose!!
Type9 flange dims
Hi,
Would anyone have same information as this in Higher resolution?
When I View or print I cannot read the dimensions.
Thanks
|
|
|
theduck
|
| posted on 2/12/19 at 11:36 AM |
|
|
quote:
Originally posted by Paul Turner
From memory off the shelf the RWD one is thinner but they will make one to the full 30mm if you ask.
Have you tried a wanted in the Caterham forum?
I tried that one some of the caterham groups, got banned almost instantly for not owning a caterham 
|
|
|
.jpg)
