NickS
|
| posted on 8/10/04 at 11:43 AM |
|
|
1300 X-Flow engine rebuild
Does anyone know the correct torque settings for the nuts when re-attaching the cylinder head to a 1300 X-Flow?
And if they have to be put back in a certain order?
Thanx
|
|
|
|
|
Markp
|
| posted on 8/10/04 at 05:22 PM |
|
|
xflow
Hope this helps to start with
 
Rescued attachment ;;l;l;l;,..jpg
|
|
|
Markp
|
| posted on 8/10/04 at 05:27 PM |
|
|
straight out the book, so if it's wrong it's the book not me
 
Rescued attachment tight.jpg
|
|
|
NickS
|
| posted on 11/10/04 at 11:38 AM |
|
|
Re: 1300 X-Flow rebuild
Thanks, Mark - managed to get the head back on this weekend.
One point of interest - friend's torque wrench didn't go down low enough to accurately set the lower figures - had to guesstimate and
tighten gradually to the higher settings in the correct order.
(Said didn't know of any that went down any lower!)
Cheers.
|
|
|
