i_froloshki
|
| posted on 5/7/12 at 12:54 PM |
|
|
MT75 gear lever pin problem
Hello all,
i have problem with the pin under position 5. It is very loose and if falls from the engine/gearbox vibration. Can i put a bolt there and secure it
with nut or should i look for another solution? Any ideas? I think there should be some gaitor there - does it cover and hold it?
 
pin problem
Thanks in advance
Yavor
[Edited on 5/7/12 by i_froloshki]
|
|
|
|
|
Chaz
|
| posted on 5/7/12 at 02:32 PM |
|
|
Hi there, interesting you say this as I had the same problem but only remember now you mention it. I think I just tie wrapped it!!! I have done 1500
miles in it so no probs. if you find a better solution let me know.
Are you mounting it to a zetec?
|
|
|
big_wasa
|
| posted on 5/7/12 at 03:38 PM |
|
|
There is a wire clip that goes around it. You can see there is a groove that it sits in. Will see if I can find a photo.
|
|
|
hootsno1
|
| posted on 5/7/12 at 05:03 PM |
|
|
GBS do a replacement part much easier to change than the standard ford one 
If a little hammer won't fix it get a bigger hammer
|
|
|
zetec-phill
|
| posted on 8/7/12 at 12:11 PM |
|
|
if its the pin that goes through the gear selection rod..?
i bought a new lever a carriage for mine fron ford, a it came with a bolt a locknut
|
|
|
