owelly
|
| posted on 5/11/10 at 09:21 AM |
|
|
WTD Ford gearbox pattern.
Has anyone got a dimensioned drawing for the Ford bellhousing pattern. The bit that bolts to the back of the engine. And whilst I'm pestering,
has anyone got a drawing for the front face of the type 9 gearbox, specifically, the register, which is also the front bearing retaining trumpet.
Cheers folks.
http://www.ppcmag.co.uk
|
|
|
|
|
MikeR
|
| posted on 5/11/10 at 10:34 AM |
|
|
I've got it in electronic form somewhere - think it was part of the zetec engine dxf. I'll have a hunt for you but others may find it
quicker.
|
|
|
ChrisW
|
| posted on 5/11/10 at 11:03 AM |
|
|
Hi Mike
That 'zetec dwf' file you refer to... what is it??
Does it have a drawing that could be adapted into a blanking plate for the Zetec block oil breather?
Sorry to hijack the thread Owelly!! 
Chris
|
|
|
MikeR
|
| posted on 5/11/10 at 12:04 PM |
|
|
Its a ford technical diagram that shows the size of the zetec engine. I think its got views from the top, side and rear.
Haven't found it yet, but i'm still hunting.
|
|
|
dhutch
|
| posted on 5/11/10 at 12:52 PM |
|
|
Sounds good, gotta love a DXF!
|
|
|
owelly
|
| posted on 5/11/10 at 01:19 PM |
|
|
Cheers MikeR. Leave no stone unturned and no sofa cushion in place.....
http://www.ppcmag.co.uk
|
|
|
MikeR
|
| posted on 5/11/10 at 02:07 PM |
|
|
currently got window installers in - so the house is already a mess.
Thinking about it - it may have been a jpg, but still not found it.
|
|
|
MikeR
|
| posted on 5/11/10 at 05:24 PM |
|
|
found it - only issue is its not quite what i remembered. Its a jpg 'scale' drawing of the engine. It shows the bellhousing bolts and has
some sizes of other bits. Therefore you may be able to scale it and work out the information you need. On the other hand, you could try approaching
ford for the details quoting the diagram.
 
Zetec scale drawing
|
|
|
gavin174
|
| posted on 5/11/10 at 07:26 PM |
|
|
why not buy one of these..
FORD 2.0L PINTO GEARBOX SANDWICH PLATE TYPE 9 ESCORT on eBay (end time 07-Nov-10 19:10:08 GMT)
would give you all the measurements you need for the engine end
http://www.essexkitcarclub.com
|
|
|
owelly
|
| posted on 6/11/10 at 09:09 AM |
|
|
Cheers Mike. I hope it will either save me a lot of time or make my life really hard!!
http://www.ppcmag.co.uk
|
|
|
