goaty
|
posted on 22/1/10 at 08:32 PM |
|
|
Mazda 6 speed
anyone knwo anything about the mazda 6 speed box? froma 2007 mx5. Should go straight onto the duratec but what is the input shaft like? and the output
and size??
searching google but hard to find something
cheers
|
|
|
scootz
|
posted on 22/1/10 at 08:48 PM |
|
|
I have one in the garage... can find out for you tomorrow!
It's Evolution Baby!
|
|
scootz
|
posted on 23/1/10 at 01:33 PM |
|
|
VERY approx measurements as I couldn't find my verniers...
Output spline Dia = 25mm
Output Housing Seal Dia 40mm
Input shaft length = 55
Input Shaft Spline Dia = ... Forgot to measure it, but it takes a Zetec clutch if that helps!
Just noticed it's a cable-clutch... happy-days, no faffing about with a clutch m/c!
PS - it's for sale if you're interested.
gbox article extract
It's Evolution Baby!
|
|
RK
|
posted on 23/1/10 at 02:21 PM |
|
|
That is nice. They are reputed to be one of the best gearboxes ever.
|
|
goaty
|
posted on 24/1/10 at 04:00 PM |
|
|
whats the over dimensions of it like in comparison to a type 9???
just to see if it would fit in my chassis...
cheers
|
|
mconley3
|
posted on 29/1/10 at 01:47 PM |
|
|
A couple of my old posts:
http://www.locostbuilders.co.uk/viewthread.php?tid=122121
http://www.locostbuilders.co.uk/viewthread.php?tid=121758
The transmission is in the car, so I can't take input or output shaft measurements. When I had the drive shaft made, the shop told me the
output slip yoke was a standard Mazda RX/7 piece. No other details.
Another note, the MX5 transmission puts the engine at a 10o tilt to the exhaust side. Chris from raceline does sell a 10o wet sump and throttle
bodies. They are not on his website yet, contact him for details.
Mark
[Edited on 1/29/2010 by mconley3]
|
|
goaty
|
posted on 29/1/10 at 06:22 PM |
|
|
ok, think i will plan something else, justr saw one on ebay and wondered what was involved. Dont want to start playing about with my engine now after
whats been done so far.
many thanks for all the info though guys
|
|