supercat
|
| posted on 1/4/09 at 10:29 AM |
|
|
Zetec Sensor help
Hi,
Does anyone know what this sensor location picks up (seems to be oil) and what thread it is? Its not the same thread as the oil sensors the inlet side
of the block, want to see if I can use it for Oil Temp? Zetec Blacktop engine...
Cheers,
James
 
zetec_oil-2
|
|
|
|
|
whitestu
|
| posted on 1/4/09 at 10:32 AM |
|
|
I think that is for the Crank locking pin, used when changing cam belts / cheking valve timing.
Stu
|
|
|
stevec
|
| posted on 1/4/09 at 11:03 AM |
|
|
It is the hole for the Timing pin for the crankshaft position. I believe it is m8x1.25 thread.
Steve.
|
|
|
r1_pete
|
| posted on 1/4/09 at 11:06 AM |
|
|
Definately the crank TDC locking pin, you screw the pin in and it prevents the crank rotating clockwise past tdc.
|
|
|
Dusty
|
| posted on 1/4/09 at 02:03 PM |
|
|
Fit with locktite. Lots of oil comes out fast if it comes loose and falls out at a trackday!!!!! Instant Billy-Nomates. I speak from experience.
|
|
|
