blakep82
|
 posted on 24/12/08 at 02:19 AM |
|
|
straight type 9 gear lever
i don't like the bend its got in it 
anyone know a decent locost way of making a short straight one?
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
|
|
gavin174
|
| posted on 24/12/08 at 08:03 AM |
|
|
what bend?
the type nine stick is straight...
if you hit it hard enough where the bulge is it comes apart..
may find this too short but you can weld to it to make it longer..
a link to making a quick shift.. i made a spacer out of perspex rather than araldite..
http://www.joeybrown.co.uk/quickshift/quick.html
 
Rescued attachment 4014_2.jpg
http://www.essexkitcarclub.com
|
|
|
stevec
|
| posted on 24/12/08 at 09:26 AM |
|
|
I took mine appart at the rubber joint and put a thread on bit that was left.
It is just the right length for me.
Link to picture
Steve.
[Edited on 24/12/08 by stevec]
|
|
|
omega0684
|
| posted on 24/12/08 at 11:07 AM |
|
|
You could buy a Quaife Short shift type 9 lever, it will need cutting down as its about half inch thick and 9" in length but there is no bend in
it!
|
|
|
blakep82
|
| posted on 24/12/08 at 12:15 PM |
|
|
Just to clarify, its this bend here i want rid of
 
Description
my gear lever has already been cut down by the last owner. i quite like the length of it, and i want to try it in the car first before i try and
shorten the throw of it.
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
austin man
|
| posted on 24/12/08 at 04:44 PM |
|
|
cut across the angle and spin through 180 reweld or clamp it in the vice and exert huge amounts of pressure
|
|
|
.jpg)
