Pat...
Rescued attachment prop.JPG
Can I just araldite it back on in the same place (clearly marked) or is it more technical than this?
Pat...
Your lucky still to have the weight and do you trust the glue to hold it?? If it were me i'd drill a hole in it and then puddle weld it to the shaft and dress back flat so the weight was the same again
yea weld it back on, a tack each end will do it or puddle weld, either way
i take it you was'nt thrashing it when it came off, mine did at cadwell and the rear uj exploded at the top of the mountain
http://youtube.com/watch?v=UmFYFixyH44
Fortunately the prop didn't let go - just a weight came of.
Did notice this morning that the prop adaptor at the front had come loose as well!
Pat...
quote:
Originally posted by tcr
i take it you was'nt thrashing it when it came off, mine did at cadwell and the rear uj exploded at the top of the mountain
http://youtube.com/watch?v=UmFYFixyH44
quote:
Originally posted by Avoneer
Fortunately the prop didn't let go - just a weight came of.
Did notice this morning that the prop adaptor at the front had come loose as well!
Pat...
Foget the prop, who's the dead guy you've just run over??????
Pat...
P.S. Cheers - in the process of checking everything.
that would be me realizing how close i was to meeting the big man
[Edited on 2/9/07 by tcr]
This look ok or shall I grind dome off the welds?
Pat...
Rescued attachment prop.JPG
I nipped the cornes off the plate before welding.
Pat...