Anyone got the wiring information for the above i.e. colour / positions / functions of the wires connected to the throttle pot of a carbed blackbird.

thanks

it measures an sweep.....

an fast movement to compensate the ignition timeing..

one will be ground, one will be 5 or 12volts (think 5)

one will be signal..(high impadance) entrance..

tks

the ground one you find easyly to check with chasis..

the other 2 is question of enable loom
and check wich of the 2 has power...

in realyty it could work with just 2 but ok..

they can also use 3..

don't suppose anyone has a spare one of these knocking around or could tell me where to get one? Mines rather broken.

I downloaded the cbr 1100 service manual looking at the wiring diagrams I have produced the picture below. Does it look about right ?

The G/O and Y/R wires are common to other sensors so I think they must be the ground and 5v power. The R/Y is connected directly to the ECU so must be the signal ?

[Edited on 12/7/05 by givemethebighammer]
Rescued attachment blackbird TPS.JPG