Helping out a mate fitting an ST170 onto an MT75 box - no issues but now find that the starter motor can't fit as it fouls up against the alloy part of the sump. Even after shaving off much of the sump excess, the starter still fouls up against the contours of the sump.

Any suggestions? Anyone use a Brise or a Wosp?

Grind more off:


starter2

That's a QX Components QS1221 starter if you need a slim one.

I didn't like the look of the ground sump, so used an all alloy one with a couple of reliefs


Phase 2 sump on phase 3

Had a relief cut out in my zetec sump

quote:

---

Originally posted by r1_pete
Grind more off:


starter2

That's a QX Components QS1221 starter if you need a slim one.

I didn't like the look of the ground sump, so used an all alloy one with a couple of reliefs


Phase 2 sump on phase 3

---

@r1_pete, I see another one of your pics shows a QX Components Ltd label so not a QH part at all - my mistake! I'll contact them tomorrow, cheers!