anyone got a duratec confirm something for me.....

want to know if the bottom 2 bolt holes on the water pump side of the block are square to the crankshaft....

the spacing would be good too

want to use these for my alternator mount, but the engine is in at the moment, and cant get a good view of it

dave

I have used them to mount my alternator, manufactured my own bracket from 4mm flat bar

ta
done the same

need to top bracket now, but that can wait till the engine comes out.... again

Attempt at the spacing for you:


Description

Then subtract the width of one bolt (7.89mm):


Description