Not decided if I want to run a long aluminium tube between tank and radiator to save weight and thus reduce strain on the radiator rail or use hose, like in photo, hmmmm........
Rescued attachment DSC06012.JPG
... about which of the 3 options for plumbing my headere tank that I posted earlier I had gone for, well the wait is over, It is this one.
Not decided if I want to run a long aluminium tube between tank and radiator to save weight and thus reduce strain on the radiator rail or use hose,
like in photo, hmmmm........
Rescued attachment DSC06012.JPG
are you running a temp sender that normally earths by touching the block?
If you are then that remote inline temp sender won't work.
I think that that fitting has got a hole in the top left corner for attaching an earthing cable if necessary.
yes - the adapter for want of a better word - has a small tapped hole, no doubt for earting poiposes .... but that is neither here nor there since I
will be fitting the radiator fan switch - it has 2 contacts so earthing is not required.
the adapter was drilled and tapped to take M14 sender.