Making lots of swarf....


Ali crank pulley 1


Ali crank pulley 2

New 120mm crank pulley for the duratec to suit the rotrex install a bit better.

Going to have a new trigger wheel laser cut to fit on the back which will then be bolted on in the correct place.

Opened a dispute over the forged rods which havent shown up after 6 weeks, and the seller is non responsive. So looks like I will be sourcing the rods from the same company who supplied my pistons after all. Anyone else want any performance parts from these guys?

http://www.importperformanceparts.net/

Shipping is about 7-10 days from the US. Highly recommended for ford tuning parts! They have a netherlands place as well, but it seems to work out cheaper to order from the US one due to the exchange rate.

David

Very nice Dave - your getting handy with the lathe then

Might be after another little turning job doing soon myself.

looks sweet dave nice job nice to have the skill to make bits and bobs

Love it

Nice work there.
I was going to say you've done someone a good turn, but I'll get me coat instead....
John.

hi david, i got a little scared when i undid my crank pulley and found it was not keyed at al.lol

mindy you i did struggle to undo the bolt.

nice work

stuart

Do get it keyed. Scholar engines can do it for you at a reasonable price.

Especially important if you plan to drive a supercharger off it!

are you getting your keyed?

i have just been reading this website

have you seen it.

stuart