this is as low as it will go due to starter motor bulge in gearbox housing getting in way of chassis rail; it is resting on 10 mm block as I mock up the engine moutns.
Engine is about 20 mm higher at front than rear.
Does that seem right?
As far as I know, the only other point of attachemnt to chassis is at the rear of the gearbox - by raising that I would be able to pivot the gearbox/engine assembly thus lower the front.
Anyone see any problems in doing that?
There are no issues with lowering the sump - (I have a chopped down one)
Rescued attachment DSC04514.JPG