pekwah1
|
| posted on 16/7/17 at 08:34 PM |
|
|
Swivel end screw thing
Hi guys,
Hoping someone can help, my rear view mirror has a part inside that allows it to swivel around but it's made of plastic and lasted not very long
before splitting.
Does anyone know where I can get something like this made of metal?
http://www.wdscomponentsusa.com/images/8635/11/swivel-end-screw-wds-673
It has the ball on one end and a female m6 I think on the other.
Thanks in advance.
Andy
[Edited on 16/7/17 by pekwah1]
|
|
|
|
|
Bigheppy
|
| posted on 16/7/17 at 08:51 PM |
|
|
Tailgate gas ram perhaps or something similar
|
|
|
r1_pete
|
| posted on 16/7/17 at 08:56 PM |
|
|
what size is the ball? I have some throttle linkage parts, which have abour a 6-8 mm ball
|
|
|
pekwah1
|
| posted on 16/7/17 at 09:03 PM |
|
|
Thanks,
I've realised that it was quite stupid not to take a photo or measure it.
I'll have a check tomorrow
|
|
|
r1_pete
|
| posted on 18/7/17 at 05:44 PM |
|
|
Found this on the shelf and thought of your post.
 
Balljoint99
Any good?
|
|
|
pekwah1
|
| posted on 18/7/17 at 05:46 PM |
|
|
Hi, thanks not sure that would be...
It needs a 10mm ball, I've taken a photo which I'll post in a second
|
|
|
pekwah1
|
| posted on 18/7/17 at 05:50 PM |
|
|
|
|
|
r1_pete
|
| posted on 18/7/17 at 06:11 PM |
|
|
No worries, this may help you out, the linkages I have are 8mm
https://www.ebay.co.uk/itm/252227620654
|
|
|
obfripper
|
| posted on 18/7/17 at 06:18 PM |
|
|
Something like this?
Steel gas strut pivot 10mm ball m6 stud/pin/bolt/foot x2
There's plenty of similar ball studs in the other viewed bit as well.
Dave
|
|
|
pekwah1
|
| posted on 18/7/17 at 06:55 PM |
|
|
Nice one thanks guys, I think I could knock something up from that!
|
|
|
