Hi

Hoping to start fitting my headlight protecters this weekend any tips for attaching/fitting/trimming the perspex etc i know they will need a small bit of trimming and was thinking of a dremel type tool

Is it worth fitting a rubber type trim to the outers ?

Thanks

Nick M

Hi, sorry i've only just got around to replying. I fitted mine last year and ended up 3D printing some brackets to screw to the body and the covers. i didn't trim the covers and there wasn't really room for an edge trim.

i'll try to get some pictures tomorrow and send them over.

Paul D

Description

here's one picture

Hi Paul

Thanks they look very neat, i might be able to make some small brackets using an old after market pedal set which have backing strips that have threaded reinforced holes cut in them.
Think i will have to trim one of the 3 sides a little and as you said no room for trim.

Ta

Nick M