They are the main disconnect plugs for a 1966 mustang.

I'm trying to help a mate who is restoring one get these connectors. I can find full looms but not the plugs on their own.


Description


Description

Thanks

look similar to used in escort and capri etc,i have an old loom in the garage,ill have a look in the morning.
does it have to be identical ?.

They are bonded connectors in 70's ford looms, I doubt you will find anything that enables you to make something up.

Look remarkably similar to those used on BL cars of the 70's too. Possibly Lucas? but they do seem moulded onto cables.

Pretty standard 1960s/1970s Ford --- you can clean connectors by soaking them in a vinegar then water wash, then wash with baking soda solution, then water rinse and finally spray with contact lubricant..

If you cant find the moulded counterparts you can slip female bullet connector tubes on the males then use bullet connectors on the corresponding wires, I remember doing this succesfully when building specials in the 70s

http://www.vehicle-wiring-products.eu/section.php/177/1/4-7mm-bullets-sockets-snap-connectors

I found a 4 way and a 2 way in pairs and a spare 4 way if thats any good

Have a look at Yazakis catalog. If you find it they will send out a sample of up to 10 parts, don't forget to order all the terminals as well as the housings.

http://connectors-catalog.sys.yzk.co.jp/yazaki-web/english/index.html