Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Hope you can help
vinnievector

posted on 26/9/08 at 08:07 AM Reply With Quote
Hope you can help

Having problem getting my head around how to power the ign coil as i cannot make sense of the rapid fit loom i have .
I can turn over the eng , and as i switch off the ign i get a spark but not as the eng turns over , i guess this is because the ign barrel diverts all the feed to the starter so how do i over come this problem . Ta Vin,

Following the road of enlightenment by other locostbuilders

View User's Profile E-Mail User View All Posts By User U2U Member
graememk

posted on 26/9/08 at 08:08 AM Reply With Quote
you have it wired to the aux on the ignition not the ing, aux goes off whilst cranking the engine over where as the ign stays on.






View User's Profile Visit User's Homepage View All Posts By User U2U Member
Macbeast

posted on 26/9/08 at 08:13 AM Reply With Quote
If you are using a distributor with points that don't break (eg cos of really worn bit that follows the cam ) you would get this.
View User's Profile View All Posts By User U2U Member
vinnievector

posted on 26/9/08 at 08:19 AM Reply With Quote
Hi

Its a new coil and dizzy ,so wot feed should i use from the ign to use . so wots the best way to wire up a ign curciut
View User's Profile E-Mail User View All Posts By User U2U Member
Macbeast

posted on 26/9/08 at 08:29 AM Reply With Quote
If you're using Sierra ignition switch, the black/yellow is the feed to the coil (and all ignition controlled feeds) Yellow is ancillaries and most people don't bother with it.
View User's Profile View All Posts By User U2U Member
vinnievector

posted on 26/9/08 at 08:35 AM Reply With Quote
thanks Mac so this black blue feed where should that go after. The fuse box relay or direct to the coil

[Edited on 26/9/08 by vinnievector]

View User's Profile E-Mail User View All Posts By User U2U Member
Macbeast

posted on 26/9/08 at 08:47 AM Reply With Quote
Black/blue is feed to starter solenoid and also to the black/green on the ignition amplifier module for some reason that nobody has explained. I think most people don't bother.


Ignition diag
Ignition diag


So, not shown here is connection from 50 (black/blue) to starter solenoid This feed is powered only when you are turning key to start it.

I'm sorry, I'm not familiar with the Rapidfit loom so can't advise on which rapid fit wire connects to which ignition switch wire.

[Edited on 26/9/08 by Macbeast]

View User's Profile View All Posts By User U2U Member
vinnievector

posted on 26/9/08 at 09:00 AM Reply With Quote
Thanks again i have the day off so give it a go wish me luck
View User's Profile E-Mail User View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.