I hope someone can help.

I have Fireblade engine with wiring loom. This at present looks like spagetti that has paper labels everywhere. As bikes dont have hazards can anyone help as to the easiest way to install hazards....Bearing in mind that wiring is not my strongest point and child like instruction would be greatly appreciated.

if you are using a sierra coumn most of the wiring and stuff is in that.

you dont say what swithcgear you are using so its a tad hard to give more details!

atb

steve

All the bike switchgear. Extending the loom for the lights etc

just splice a hazzard switch and flasher unit into the two output wires,use diodes or it will feed back to bothj sides

If you can get hold of a proper harard switch then this diagram is the typical way of wiring them up.
Rescued attachment Hazard.jpg

Cheers that is certainly helpful

Will go and get the switch and relay etc tomorrow