Koso install cont

6 magnets indexed and pushed into 6mm holes with the n pole outwards. Epoxy put in and hydralic lock achieved and over come by pressing in.
Tough to get in less likely to come out

[Edited on 8-5-07 by mangogrooveworkshop]
Rescued attachment koso install.JPG

RIGHT
The next thing I want to do is to tap the second temp sensor into an oil source to read the temp of the oil.
Its a fazer 1000 04 motor so I need some ideas. thinking the head cover or the sump plug. Im using a pelapump to do oil changes so that would stay put.
That area is really exposed so thats a last resort.....
Ideas folks...... and what thread is it?