Hi Guys

As you can probably guess I am into the lovely job of connecting all those lose ends of wires onto the appropriate parts in my engine bay...

The next issue I could do with some help on is the oil pressure sensor.

Currently I have 2 wires from my luego loom that are labelled "Oil pressure sender" and "Oil pressure switch". I also have a facet fuel pump that states that it should be fed form the oil pressure switches "P" terminal.

On my Rover V8 engine I can see the 3 prong oil pressure switch and another device next to it that has a 1 prong connector.

Can anyone let me know what each of the pins are for and therefore what should be plugged onto them?

I can attach a photo later if it helps?

Thanks in advance.

Mark

Picture as promised earlier...

If anyone could let me know what should connect to each pin I would appreciate it.

Mark
Rescued attachment oil pressure switch.jpg