ZX9R NO SPARK

Hi

Guys

I have aZX9R C1 does any one know any good wiring guys apart from the oracle steve keenan as he is fully booked

Using a Sierra Ignition and
Orginal bike ignition
Vicky Green Loom
ETB Dash

all the wiring is in and connected

we have no spark / and no power to fuel pump

Does anybody know what the 4 wires out of the bike ignition are connected to as somthing tells me where missing somthing here.


plus me and charlie are getting splinters from scratching our head so any help would be apprieciated thanks Chris

Whats your e-mail addy?
can send you a workshop book in pdf form if its any good

[Edited on 18/8/06 by ch1ll1]

From bike ignition IIRC from the 12R

1. Parking Lights
2. Line In
3. Line Out
4. Feed to ECU (after Resistor from bottom of original Kwak Ignition Barrel)

If you don't have this resistor fed (IIRC it's the grey wire) wire you will have no spark and fuel pump wont work.

HTH

Hi

so i do need the resistor even with the orginal kawsaki ignition

not if you have the ignition lock (barrel and key) connected to it

[Edited on 18/8/06 by ch1ll1]

[Edited on 18/8/06 by ch1ll1]

Hello,

I'm also using a zx9r in my MK indy, don't know if it will help you, but iff you take a look at my website, i've explained how to start the engine.

You could bypass the fuelpump relay and connect the pump directly to the battery..
Have you also shortened the sidestandswitch and neutralwistch...???

And yes you need a 100 ohm resistor if youre not going to use the ignition key..

[Edited on 18/8/06 by badding]

Rescued attachment test.jpg

Hi

Thanks for that
i know have power to the fuel pump

and power to the coils but still no spark

Thanks Chris