Board logo

Anyone know where I can get one of these ?
givemethebighammer - 10/7/05 at 06:53 PM

scrapyard prefered otherwise electronics supplier ?

I think they call them 3 pole junior timer housing ?.

I need to join a TPS sensor to my ecu (this would normally plug straight on to the weber TPS). However I am experimenting with some bike carbs and want to connect the honda TPS to my ECU without butchering the loom.

thanks Rescued attachment connector1.JPG
Rescued attachment connector1.JPG

stevebubs - 10/7/05 at 07:07 PM

Vehicle Wiring Products

RS Components

givemethebighammer - 10/7/05 at 07:10 PM

Thanks neither seems to stock a 3 pole male housing of thie type. 2 pole yes but 3 no ?

omega 24 v6 - 10/7/05 at 07:28 PM

They look very similar to many of the fuel inj plugs or cam sensor plugs on my v/hall. However i'm not sure if they are 3 pin or not.
If you have a look in a commercial vehicle scrap yard for a leyland daf 7.5 tonner ( i think its a model 45 or a 55 ) then there are plugs with 3 pins similar to these.
Sorry if this is a bit vague i'll try and have a look for one on a new daf tomorrow if i've time.

madman280 - 10/7/05 at 07:37 PM

Looks to be a bosch style connector. Maybe a wander around a scrap yard might yield a european vehicle with the right connector

stevebubs - 10/7/05 at 08:23 PM

quote:
Originally posted by givemethebighammer
scrapyard prefered otherwise electronics supplier ?

I think they call them 3 pole junior timer housing ?.

I need to join a TPS sensor to my ecu (this would normally plug straight on to the weber TPS). However I am experimenting with some bike carbs and want to connect the honda TPS to my ECU without butchering the loom.

thanks


U2U Colibriman and see if he has a spare bit of loom lying around.

Alternatively, contact a bike breakers

....or scout around a biker gathering with set of wire cutters :O

Mix - 11/7/05 at 06:18 AM

Try Martin Fox at MEF Motorsport, he is supplying me with the plugs and sockets for my injection.

<martinfoxg3zuz@ukonline.co.uk>

Mick

davidwag - 11/7/05 at 07:40 PM

Hi
The photo is of crank position sensor wiring on a vauxhall vectra type ecotec engine. You could try that.
David

givemethebighammer - 11/7/05 at 08:08 PM

thanks,

I'm off to scrapyard tomorrow lunchtime to see what I can find. I also found a sierra master cylinder low fluid warning cap in the garage this evening. The plug is the same as the TPS one so I may be able to make a 3 pin male socket from the cap socket.

.........off to scrapyard with pair of wire cutters
thanks

givemethebighammer - 12/7/05 at 01:02 PM

Got one Davewag was in the right area

Vauxhall Calibra 8v K reg - cable that is attached to the cam belt cover.

thanks

NS Dev - 12/7/05 at 01:38 PM

was going to say (too late now!!) that Davewag is dead right, Vauxhall crank position sensor lead has those connectors (and is what is in the pic on an XE I believe)

davidwag - 12/7/05 at 09:47 PM

Cheers

Glad to know I could be of some help!!!

David