Mash
|
| posted on 16/2/17 at 03:55 PM |
|
|
DIY inlet manifolds
Hi Folks,
Thinking of getting some bike carbs for my Pinto, and looking at getting one of these:
FORD PINTO OHC RS2000 DIY BIKE CARB THROTTLE BODIES INLET MANIFOLD KIT 41mm PIPE
They do various diameters, so, any ideas what they are like? Also what diameter should I be looking for?
Sorry if they are stupid questions 
|
|
|
|
|
coozer
|
| posted on 16/2/17 at 04:10 PM |
|
|
Ideally you want one that matches the head ports but obviously not smaller than the carb choke diameter.
1972 V8 Jago
1980 Z750
|
|
|
Mash
|
| posted on 16/2/17 at 05:14 PM |
|
|
Thanks C,
What about the diameter of the silicone tubes to go over the carbs? Is there a fair bit of leeway there? sorry , but I'm in new territory with
bike carbs, now bike wheels, yes I know them OK 
|
|
|
jacko
|
| posted on 16/2/17 at 07:05 PM |
|
|
 
top view painted manifold
I made my own for zx9r carbs to pinto head [ No sorry i dont make them any more ]
but is you decide to make one have a look in my archives under zx9r carbs and manifold
jacko
|
|
|
redturner
|
| posted on 16/2/17 at 09:30 PM |
|
|
By the time you have got that lot welded together you would be far better off going to someone like DanSt and getting an ally one already welded
together. I did and have no regrets.....
|
|
|
Mash
|
| posted on 16/2/17 at 10:20 PM |
|
|
Yes the DanST ones are really nice, but a bit out of my league
thanks Jacko, I like yours
|
|
|
