what size trigger wheel have you used for a pinto pulley??

is fitting using the original bolt and then drilling an fitting a roll pin ok?.

cheers
Ray

[Edited on 11/2/08 by rayward]

The size of the wheel is unimportant as long as it a 36-1 for reference my one is almost a ring like a starter ring gear and about the same diameter as the crank pully it is bolted to

[Edited on 11/2/08 by snapper]

finger trouble i will get it in the next post.

[Edited on 11/2/08 by snapper]

[Edited on 11/2/08 by snapper]

hopefully a photo will appear
Rescued attachment Pinto 018s.jpg

The VR sensor could do with being higher up on my car as the bottom of it sticks through the engine bay floor a bit, it was alright in the Sierra it came out of but a bit low for a 7.
Also if you can get the trigger wheel behind the crank pulley you do not need to move the VR sensor if you change the belt