fuel pressure regulator

Received it in a job lot today....has no markings.
Interested to find out who makes them and what the spec is...

Thanks
Mike

A zinc plated one!

I had something similar on my old engine, which (i believe) was from a renault fuego or espace. It did raise the static fuel pressure, but i needed a vacuum reference and rising rate for the new install so binned it.

Mine had a large grub type screw, rather than a nut and bolt.

ETA: it didnt have a flange on it either, but yours may be just a standard item like mine was, to adjust static pressure.

[Edited on 9-1-13, by MakeEverything]


ETA:

OR

I could be wrong (See third item down)

[Edited on 9-1-13, by MakeEverything]

quote:

---

Originally posted by MakeEverything
A zinc plated one!

I had something similar on my old engine, which (i believe) was from a renault fuego or espace. It did raise the static fuel pressure, but i needed a vacuum reference and rising rate for the new install so binned it.

Mine had a large grub type screw, rather than a nut and bolt.

ETA: it didnt have a flange on it either, but yours may be just a standard item like mine was, to adjust static pressure.

[Edited on 9-1-13, by MakeEverything]


ETA:

OR

I could be wrong (See third item down)

[Edited on 9-1-13, by MakeEverything]

---

quote:

---

Originally posted by mikey p

quote:

---

Originally posted by MakeEverything
A zinc plated one!

I had something similar on my old engine, which (i believe) was from a renault fuego or espace. It did raise the static fuel pressure, but i needed a vacuum reference and rising rate for the new install so binned it.

Mine had a large grub type screw, rather than a nut and bolt.

ETA: it didnt have a flange on it either, but yours may be just a standard item like mine was, to adjust static pressure.

[Edited on 9-1-13, by MakeEverything]


ETA:

OR

I could be wrong (See third item down)

[Edited on 9-1-13, by MakeEverything]

---

Thanks for the input! The MSD one looks quite similar.
I agree it looks like it is a OEM based FPR but has the JIC fittings and adjustability. It looks as if its all made in one also (not modified). looks like it could be a good one.....maybe...? haha

Will continue to search....

---

Looks a good quality bit of kit. Adjustable plus a vacuum reference. Try it, couple up a fuel pressure gauge and you should be able to get an idea of the specs.

Looks like one of these....

Genuine HKS Adjustable Fuel Pressure Regulator with Earls fittings.

http://www.autoextreme.co.uk/hks-adjustable-pressure-regulator

just with a different bracket.

If it does as it says it could be ok.

2-5bar regulator.

Mike