I'm wiring up my EDIS8 module and I came across this on pin 3, the SAW line. Any idea what it is, and can I just cut it off? It has the Ford logo on the black part, but no other identifying marks.

It's a connector thats used to cut the SAW from the ecu to the eddis. So you can check the ignition advance with just the eddis running the ignition.

Remove it....

Paul

Ford diagram ----

[Edited on 12/12/09 by Paul (Notts)]
Rescued attachment EDIS8.gif

Thanks, that's a handy diagram. How is your conversion going?

Regards,
Dave