running my fuel lines as shown below.
Rescued attachment Image008sm.jpg
Anybody see anything wrong with
running my fuel lines as shown below.
Rescued attachment Image008sm.jpg
and terminating here..
cheers
Steve
Rescued attachment Image007sm.jpg
That's pretty much how mine are done and no probs for SVA or since. Make sure that you've accounted for any gearbox movement under acceleration though.
should be fine
[Edited on 25/3/09 by omega0684]
I would not use the sticky tape, SVA might not like that !!!
quote:
Originally posted by yellow melos
I would not use the sticky tape, SVA might not like that !!!
Very similar to mine, although I've not gone through the test yet:
are you ok clipping brake/fuel lines to the floor i thought thay had to be to the chassis would make my life alot easier
there are a lot of clips in there man, but do you have one clip holding both fuel lines running down the side of the footwell? im not sure if that is allowed as the may rub against each other and chaif. i would use separate clips.
Thanks for the feedback guys.
Must remember to swap the tape for P clips. :-)
ADAM1985 - I read on here that its frowned upon.
So I spoke to the local SVA man about
2 parallel lines of copper running straight
up the floor and he said it was fine as long
as they were not rubbing against anything,
firmly attached and not in the path of any moving parts.
He even said sure arent the pipes attached to the floor pan of your tin top.
If you stand on the floor in the seat area
you can see the floor pan flex but from what I can see the section in the tunnel
area never moves.
Its where mines going.
Cheers
Steve
Looks ok to me, although very close to the gearbox which moves a lot more than you would expect on bumpy roads and under heavy acceleration.
David
quote:
Originally posted by omega0684
there are a lot of clips in there man, but do you have one clip holding both fuel lines running down the side of the footwell? im not sure if that is allowed as the may rub against each other and chaif. i would use separate clips.
quote:
Originally posted by adam1985
are you ok clipping brake/fuel lines to the floor i thought thay had to be to the chassis would make my life alot easier