Well after a week of dicking about in the garage with engine wiring I have made a bit of progress in the electrics department, the brakes line and fuel pump and filter. I think I have the wishbones on the correct side but not 100% sure (opions welcome)

Electrics:

Engine loom after extension so it can be run with as little visable as possable.


engineloom

The holder for the R1 loom and new lighting relays.


electrics


electrics2

Front brake lines: (I think there may be some support needed on the bend what do you think?)


front brakes

Rear brakes with the beginings of the rear loom , the fuel pump and fuel filter


Rear Brakes and a bit of wire

Front upright:


wishbone1


wishbone2

tidy

very neat job!!

Well assuming it's meant to have about the same Castor as a Locost/Indy then yes, the top wishbones are the right way round!

Cheers,
James

Hi,

bones look fine to me, same way round
and up as mine.

looking good

GeorgeM

Lookin cool ( but way too tidy ).

The front end looks spot on, Though personally id turn the top hats the other way round ( the champhered washer that sits on the top pin ).

regards

agirv8

1. Front brake lines: they seem more than OK. They won't move after the fittings are tightned.
2. Rectifier: I didn't see it, but it is an exposed item in a motorcycle due to heat issues. Consider that during your assembly.