Hi all.

Could you guys take some photos of the nose and side panel contact zone?
As the nose is round and the side panel is square, I'm not sure how it will align ...

Also if you could also take some photos from the suspension holes plus the steering rack I would appreciate a lot.

Thanks in advance,
Joao

Happy fitting

Steve.
Rescued attachment PICT1493.JPG

Rescued attachment PICT1644s.JPG

I put the nose cone on and butted it up against the main body of the car, then with a felt tip ran it down the side and cut that off repeating the process till i had a nice smooth edge!! then filed and sanded to the curved shape which is easy enough once you start getting some waste material out the way!!

Good luck!!

hi steve did you get the pics for the order of fit re exhaust ???

Thank you very much, Steve.

I wasn't sure about how to fit a round nose to a straight side (vertical wise, I mean)

Anyone with a RT?

Thanks again,
Joao

Ill get you some pics today Joao. I got a little carried away by cutting slightly too much back on one side of the tub. I evened them up and used some trim. This also has the benefit of being flexible.

Small amounts bit by bit is the way to go to get the best line between nose and side panels.

Rgds

Rich

[Edited on 16/6/06 by RichieC]

[Edited on 16/6/06 by RichieC]

Steve,

how did you fix the front of the tub to the chassis?

Paul

quote:

---

Originally posted by RichieC
I got a little carried away by cutting slightly too much back on one side of the tub. I evened them up and used some trim.

---

Yeh, Sorry Joao, Ill go and take some now for you...................

Rgds

Richie
Rescued attachment DSCF0012.JPG

quote:

---

Originally posted by chockymonster
Steve,

how did you fix the front of the tub to the chassis?

Paul

---

I have a rivet on the top into the intersection of the chassis rails and a couple from underneath, rock solid

Rgds

Rich