Printable Version | Subscribe | Add to Favourites
<<  1    2  >>
New Topic New Poll New Reply
Author: Subject: Bonnet vents - any ideas
Rob Palin

posted on 5/5/06 at 03:31 PM Reply With Quote
If it's mainly a heat soak problem when you're stationary then it might be worth checking for recirculation of hot air through the radiator.

It's a common problem in stuff like trucks and taxis(!) where there's little space behind the rad. The fan pulls or pushes flow through the rad but it then returns through either gaps around the sides or even back through the edges of the rad. You're then using 80+ degree air to cool the rad and the rate of heat transfer drops significantly.

For a simple check you could sellotape cotton thread or strips of wool to something like half-straightened paperclips and poke them through the vanes of the rad at the outer edges. Put everything back together, run the fan and see if the tufts go flat against the rad or point forwards out of it (probably fluttering around a lot though).

If they point forwards you could either use a cowl on the back of the rad (obviously better with a puller-type fan) or have some splitter plates which divide the back of the fan into thirds so the air going through the fan can only go rearwards and not get pulled back through at the sides. This second option leaves the rad more efficient when you're using ram-cooling, whereas the cowl will be better for fan-driven flows.

View User's Profile E-Mail User View All Posts By User U2U Member
rusty nuts

posted on 5/5/06 at 05:55 PM Reply With Quote
Simple way of dropping the coolant temperature by as much as 20 degrees for around £15.00 . Add a bottle of Red Line Water Wetter . Does what it says on the bottle
View User's Profile View All Posts By User U2U Member
Simon

posted on 5/5/06 at 11:15 PM Reply With Quote
Darren,

To get a nice finish, may I suggest what I did to my grille?

Scribe the shape of the holes onto some hardwood - do male and female halves.

Put mesh between the hardwood and tap gently, until you have a formed mesh that can be bonded inside bonnet, but which is flush with the top of the vents holes.

ATB

Simon






View User's Profile View All Posts By User U2U Member
zetec

posted on 6/5/06 at 05:32 PM Reply With Quote
Caterham rip off....





" I only registered to look at the pictures, now I'm stuck with this username for the rest of my life!"

View User's Profile E-Mail User View All Posts By User U2U Member
<<  1    2  >>
New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.