Does anyone have a reasonable close-up photo of the leading edge on a locost nose piece. I've made my own nose to cast from but I'm a bit concerned about the 5mm radii for SVA.

The bit I'm wondering about is where the leading edge curves back on itself 180deg into the bit where the grill fits.

Sorry for the bad description, hope it makes sense, don't have a cam to send pic.

Cheers.

Is this any good?

David
Rescued attachment P1010011.JPG

Thanks for that, that's a lot more curved than mine - looks like I'll have to continue with the sanding down ...

cheers