Hi, anybody seen/got a picture of a car with side panels like this one i made up? Are there any problems with this (supposed to b like 3 big luvres)? I know in theory it will lose a bit of torsional stiffness but that shouldnt make a massive differece would it? I intend to make the middle panel removeable but well held on if you know what i mean. ps, hope you dont mind if this is your car
forgot the picture
Rescued attachment side idea.jpg
SVA sharp edges?
torsional striffnes shouldn't be an issue, as i'm sure that panel does not bear any weight (i'm not building a seven) but, as said above, do it after SVA
my car has one on each side. massivly reduced the under hood temp. If you see my avatar or look in my archive you can see the front has black pannels the overlap the stainless by arround 3 inch and are off the stainless by arround 1 to 1.5 inch
Even just one will make a difference and even more so if you panel the underside as well.
Yes i appreciate the sharp edge issue thanks, but id just have to cover it with edging strip for the test. Nobody got any pictures of more than one
vent?
[Edited on 30/4/07 by andrew-theasby]
louvres and grills used for engine cooling just have to be blunted IIRC. That said you never know what an inspector is going to decide