anybody got pics of how they did there bulk head

If u mean the battery tray area I used the GPR panel MK suppled



Battery tray

Not sure how well you can see it here, but the bulkhead and battery shelf is one piece of ali folded, and riveted to the front of the top footwell rails. The sides are folded up to make it easier to locate the bonnet. To fix it to the scuttle I used sealant and dome head bolts

[Edited on 26.01.2007 by Humbug]
Rescued attachment 2005-01-30 ST 4.JPG

did it fit properly kev or did you have to force it to fit,thats what i have been told dont know if its true

It fits fine after a bit of trimming up. The lip on the front edge overhangs by about an inch but I just removed it and trimmed it back to the bulkhead. I also had to trim around one of the fireblade cradle mounts as well

Battery tray 2





Battery tray 3