Description
Description
Description
Description
Managed t o rescue a old disabled ramp from work and it used a 2mm sheet of ali checker plate. Some trim and ALOT of sawing and grinding. The fuel filler is a Rover one from the scrappy that I 'turned' top for using a bit of 3mm ali sheet. I drilled a hole in the ali sheet and put a bolt through it. I then stuck the bolt in a 240v drill and clamped the drill in a vice. I used a metal reamer as a tool to turn the metal. I made the fuel filler fit by using some Polyprop 12mm offcuts from work.
I don't know if the fuel filler will pass IVA or not. Can any see any reason why not.
[Edited on 26/5/12 by Irony]
