I have been looking at fitting the windscreen I have had for a while and at first I thought it may be wrong shape for scuttle but not sure now. It is flat for a fair length along the bottom then curves down about 25 to 30mm.

Has anyone got a picture of their screen before fitting and after if possible,

Thanks
RD

Where did you buy the scuttle from?

Some are designed to take the Caterham windscreen. My Stuart Taylor (now Aries????) scuttle for instance - check out my photo archive.

The Caterham screen is flat'ish along the bottom etc....

I will try and post some pic later

RD

Here is what I have .........

With screen sat on top



Gap if sat on top


Or sat at bottom



Gap if sat on bottom

Full width




sat on top of curved scuttle


Do you think it would look OK with an infill piece of rubber trim ? There is a groove under the bottom rail of the frame to take a "T" or "P" shaped lip

RD

it looks a little like an MK scuttle, but from the picture of the car it would appear that your scuttle is not deep enough for an MK. An MK locost prehaps?

sorry not to have been much help.

Ditch

PS i have an mk and my screen has a rubber P seal about 50mm long that masks the car to screen join and i think it would work well on your car

[Edited on 30/3/11 by ditchlewis]

quote:

---

Originally posted by rallyingden
I have been looking at fitting the windscreen I have had for a while and at first I thought it may be wrong shape for scuttle but not sure now. It is flat for a fair length along the bottom then curves down about 25 to 30mm.

Has anyone got a picture of their screen before fitting and after if possible,

Thanks
RD

---

Send me the profile of the scuttle and I will be able to make you the exact profile