Is it nessasary to make the floor in one piece i.e. covering the prop shaft tunnel. I think this might catch muck and water.

Is it OK to make the floors in two separate plates and leave the prop tunnel open?

I went for one piece for strength and more flat floor. Just as many rivets though!

Does this answer your question?

yeah its fine to have 2 pieces, flat floor(single piece) may have a small advantage for racing but acess outways that for a road car IMO.


Description

I have never seen rivets like that Bigrich. I like them. Little things. I know

Thanks for that. I'm going for a two piece with open prop tunnel.

its a PITA with a one pice as its an engine out job to mess with the prop!

I have a 2 piece floor the same as bigrich's