Pdlewis
|
| posted on 5/3/08 at 11:45 AM |
|
|
CV Boot Kit
Hi,
Does anyone have a good supplier of CV boot kits? I figure i may as well replace them while they are on the floor but my local motor factors want £7 a
boot  and the bay of e isnt coming up with much
|
|
|
|
|
Hammerhead
|
| posted on 5/3/08 at 11:48 AM |
|
|
mnr sorted me out
|
|
|
Mr Whippy
|
| posted on 5/3/08 at 11:52 AM |
|
|
if you get really cheap boots the rubber will rot within a year, split, throw grease all over the place and you'll have to change them whilest
still on the car.
I'll spend the little extra and buy good quality ones from Ford etc.
[Edited on 5/3/08 by Mr Whippy]
Fame is when your old car is plastered all over the internet
|
|
|
Pdlewis
|
| posted on 5/3/08 at 12:05 PM |
|
|
I dont know why i always forget ford £5 a boot but they dont come with grease (cant be that hard to get) and my coz works for ford so should be some
discount involved 
|
|
|
nick205
|
| posted on 5/3/08 at 12:49 PM |
|
|
In my experience, the Ford kit came complete with grease, rubber boot, metal bands and most importantly replacement metal covers. The motor factor
kits don't have the metal covers and as you have to wreck these to remove them and do the job properly is a bit daft really.
Also IIRC the Ford kits were actually cheaper than the motor factor ones too.
|
|
|
Pdlewis
|
| posted on 5/3/08 at 06:01 PM |
|
|
which metal covers do you mean? im just trying to work out how you get the boot into the middle
|
|
|
Stuart_B
|
| posted on 5/3/08 at 07:29 PM |
|
|
I went a got a cheap kit, and it did not come with the metal bit.
Hope the picture helps.
stuart
 
Rescued attachment rear parts00000.JPG
|
|
|
Pdlewis
|
| posted on 5/3/08 at 08:00 PM |
|
|
Last stupid question how do you get that bit off?
|
|
|
Stuart_B
|
| posted on 5/3/08 at 08:26 PM |
|
|
If you got the ford sierra owners workshop, manual it is page 211 foward.
if not: Cut the metal with a hacksaw around the circumference and then down the middle, then using a pair of pilers pell back the cover.
If you need some more infromation just ask.
stuart
|
|
|
nick205
|
| posted on 6/3/08 at 03:47 PM |
|
|
Check out previous thredas on this interesting subject....
http://www.locostbuilders.co.uk/viewthread.php?tid=11231
|
|
|
.jpg)
