andyharding
|
| posted on 14/11/05 at 05:29 PM |
|
|
Harness bolt mounts
I need some threaded tube to make up my top harness mounts. 4x 2" long with a thead for SA Belt harnesses (7/16ths UNF?). Any suggestions?
Are you a Mac user or a retard?
|
|
|
|
|
Avoneer
|
| posted on 14/11/05 at 06:15 PM |
|
|
Ask Nik The Skid.
He did mine for me. Quick turnaround and good price.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
andyharding
|
| posted on 14/11/05 at 07:13 PM |
|
|
quote:
Originally posted by Avoneer
Ask Nik The Skid.
He did mine for me. Quick turnaround and good price.
Pat...
Who's is Nik The Skid and how do I contact him?
[Edited on 14/11/05 by andyharding]
Are you a Mac user or a retard?
|
|
|
Peteff
|
| posted on 14/11/05 at 07:55 PM |
|
|
Nick Skidmore
He sells on ebay and is on the list.
N.Skidmore@wlv.ac.uk
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
jonbeedle
|
| posted on 15/11/05 at 12:11 AM |
|
|
I just made mine from 20mm mild steel bar drilled it in the lathe with a 9.9mm bit and tapped it 7/16"UNF. I then cut 20mm holes into my roll bar
cross tube and welded them in. Picture below shows the bar in place before welding.
Cheers
Jon
 
Rescued attachment DSCF0012.JPG
"Everyone is entitled to an opinion however stupid!"
|
|
|
jonbeedle
|
| posted on 15/11/05 at 12:12 AM |
|
|
Job done!
 
Rescued attachment DSCF0016.JPG
"Everyone is entitled to an opinion however stupid!"
|
|
|
jonbeedle
|
| posted on 15/11/05 at 12:13 AM |
|
|
Close up!
 
Rescued attachment DSCF0029.JPG
"Everyone is entitled to an opinion however stupid!"
|
|
|
%20(WinCE).JPG)
