Wanted - 1.8/2.0 Silvertop Zetec Valves

Not logged in [Login - Register]

LocostBuilders » Forum » Wanted » Wanted - 1.8/2.0 Silvertop Zetec Valves

Water Pumps at MachineMart.co.uk

Printable Version | Subscribe | Add to Favourites

birdii

Contributor

Posts 176
Registered 1/10/05
Location Lincoln
Member Is Offline

Photo Archive Go!

Building: GTS Panther 2.0ltr Zetec

posted on 19/3/18 at 04:33 PM

Wanted - 1.8/2.0 Silvertop Zetec Valves

I've been messing about with a valve grinding setup on my lathe and have arrived at a pretty decent result. The setup uses a dremel mounted in the tool post with the slide angle setup to match the seat cutter i have.

The snag is that for the first couple of valves that i ground i hadnt realised that my 3 jaw chuck was putting the concentricity out by 5 thou - silly mistake i know.

As i dont have a collet set im now using a 4 jaw and setting up each valve.

To finish the job off i would love the chance to replace the first 3 which i have ground 5 thou out on run-out.

Does anyone have any old exhaust valves from a silver top 1.8 or 2.0 head going spare for beer tokens? The silvertop has the single collet grove.

I know i could buy new valves but i like to put the locost back into locostbuilders!

A few photos of what i have been doing:

[img]

Tool Post Grinder [/img]

[img]

Before & After [/img]

[img]

Lapped [/img]

Cheers
Dan

LocostBuilders » Forum » Wanted » Wanted - 1.8/2.0 Silvertop Zetec Valves

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.